CAT6-75 | Single Line Surge Protection





Protects High-Performance 4-Pair Cat 6 Outside Plant Cables as well as Cat 6 UTP Cables for Voice or ISDN Low-Voltage (Digital, 75V) Applications. Can also be used for End-Span POE Applications where Power and Data are on All 4-Pairs. Using 110 Punchdown In/Out.
Applications: Protects CAT6 OSP or UTP cable for Off Premise Extensions, Wireless Access Points, T-1, ISDN.
(*Made in USA of U.S. and imported parts.* )




  • Environments:  Primary and Isolated Loop 
  • Grounding Requirements Uses Electrical AC Ground 
    for use with Surge Gate Series AC Base Units 
    (See installation instructions for additional grounding information)
  • Recommended Grounding Impedance <0.5 0hm
  • Width/Height/Depth/Weight 4.25” / 4.25" / 1.5" / 0.42 lbs
  • Product Warranty 5 years
  • Connected Equipment Warranty Up to $50,000


  • Signal Perfect Circuitry Yes
  • Fused Yes
  • Performance Rating CAT6
  • Clamping Level 75V
  • Response Time 1-5 Nanoseconds
  • Capacitance <5pF
  • Operating Temperature: (-40ºF to 158ºF) (-40ºC to 70ºC)
  • Wires Protected 4-pairs
  • Termination Type 110 Punchdown




  • Primary and Isolated Loop applications
  • Exceeds TIA/EIA Standards 568 and 758 for CAT6 performance
  • Solid-state protection for fastest response
  • Use between buildings in a campus environment as a building entrance protector or in hostile industrial applications as an isolated loop protector
  • For use with CISCO POE systems
  • Can be used in high power POE (POE+) applications
  • Expandable System Protection Surge Gate Modules can be attached to one another to expand system protection as your system grows
  • 5 Year Product Warranty This surge protector shall be free of any defects in design, materials, or workmanship, or ITW LINX will repair or replace the defective product
  • $50,000 Connected Equipment